Shortcuts
|
 |
Planet WNAP-7320
|
| details: | 5GHz 300Mbps 802.11a/n Wireless Outdoor Access Point |
| hardware type: | Wireless Access Point |
| date added: | 2013-04-18 |
The WNAP-7320 is compliant with IEEE 802.11a/n standards and 2T2R MIMO technology which makes it possible to deliver data rate up to 300Mbps, six times faster than normal 802.11a wireless device. Via the embedded 14dBi dual-polarization (vertical and horizontal) directional antenna, it provides good diversity coverage and better noise immunity. Not only features high sensitivity but also the high output power up to 500mW, the WNAP-7320 can extend higher coverage in outdoor long range applications.
The WNAP-7320 supports multiple operation modes (AP / Client CPE / WDS PtP / WDS PtMP / Repeater). It also supports WISP mode, so CPE users could easily connect to Internet via WISP provider or connect to a wired network.
In aspect of security, besides 64/128-bit WEP encryption, the WNAP-7320 integrates WPA / WPA2, WPA-PSK and WPA2-PSK to secure and protect your wireless LAN. In addition, with the Dual-SSID feature you can setup two different wireless networks, the WNAP-7320 can therefore serve as a virtual access point for segmented networks tailored to any office or industrial need.
Rated to operate at the temperature from -30 to 75 Degree C and adopted IP55 and outdoor UV Stabilized Enclosure; the WNAP-7320 can perform normally under rigorous weather conditions including heavy rain and wind. With the proprietary Power over Ethernet (PoE) design, the WNAP-7320 can be easily installed in the areas where power outlets are not available.
| WNAP-7320 Features |
| General
|
| Availability: |
currently available
|
| LAN / WAN Connectivity
|
| WAN ports: |
1
|
| WAN port(s) type: |
10/100 Base-TX (RJ-45)
|
| WAN port auto cross-over: |
 |
| LAN ports: |
1 |
| LAN ports type: |
10/100 Base-TX (RJ-45)
|
| LAN ports auto cross-over: |
|
| Router
|
| NAT routing: |
|
| Multihomed: |
|
| DMZ: |
|
| Port forwarding: |
|
| DHCP server: |
|
| DHCP client: |
|
| Dynamic DNS client: |
|
| UPnP: |
|
| Routing Protocols: |
Spanning Tree Protocol (STP)
|
| Wireless
|
| Maximum Wireless Speed: |
300 Mbps (Wi-Fi 4)
|
| WiFi standards supported: |
802.11a (Wi-Fi 2)
802.11n (Wi-Fi 4)
|
| Wifi security/authentication: |
WEP
WPA (TKIP)
WPA2 (AES)
802.1X (EAP-MD5/TLS/TTLS/PEAP)
Wireless MAC Address filtering
SSID Broadcast disable
|
| WiFi modes: |
Access point
Wireless client
Wireless bridge (PtP)
Multipoint bridge (PtMP)
Repeater mode
WISP mode
|
| internal antenna(s): |
1 |
| Antenna gain: |
14 dBi |
| Transmit Power: |
+27 dBm |
| Receiver Sensitivity: |
-92 dBm |
| Default SSID: |
default |
| Multiple SSID: |
|
| WDS compatible: |
|
| WMM (QoS): |
|
| WPS (Wi-Fi Protected Setup): |
|
| Firewall
|
| SPI firewall: |
|
| DoS / DDoS protection: |
|
| Filtering: |
Domain/URL blocking, IP Address filtering, MAC Address filtering
|
| Device Management
|
| Default IP address: |
192.168.1.1 |
| Default admin username: |
admin |
| Default admin password: |
admin |
| Administration: |
Web-based (LAN)
Quick Setup Wizard
|
| Firmware upgradeable: |
|
| Configuration backup/restore: |
|
| Event log: |
|
| Usage Statistics: |
|
| Diagnostic functions: |
|
| Misc hardware info
|
| RAM: |
32 Mb |
| Flash Memory: |
8 Mb |
| SNMP support: |
SNMP v.2
|
| IPv6 support: |
|
| NTP client: |
|
| Power over Ethernet (PoE): |
|
| Links
|
| Product page: |
http://www.planet.com.tw/en/product/prod... |
| Datasheet: |
http://www.planet.com.tw/en/product/imag... |
| Manual: |
http://www.planet.com.tw/en/product/imag... |
| Quick Install Guide: |
http://www.planet.com.tw/en/product/imag... |
Please use the Add Comment function below to review devices you have used (please be descriptive).
If you find an error in our database, or have additional information about the product,
please
|
