| RTA1046VW Features | 
			
		| General | 
	
	| Availability: | discontinued | 
		
		| LAN / WAN Connectivity | 
	
	| WAN throughput: | 24 Mbps 
 | 
	| WAN throughput upstream: | 1 Mbps 
 | 
	| WAN ports: | 1 
 | 
	| WAN port(s) type: | DSL/ISDN/POTS connector (RJ-11) | 
	| LAN ports: | 4 | 
	| LAN ports type: | 10/100 Base-TX (RJ-45) | 
	| LAN ports auto cross-over: |   | 
	| RJ-11 FXS VoIP phone ports: | 2 | 
	| RJ-11 FXO VoIP PSTN wall jack port: | 1 | 
		
		| Router | 
	
	| NAT routing: |   | 
	| Multihomed: |   | 
	| DMZ: |   | 
	| Port forwarding: |   | 
	| Port triggering: |   | 
	| DHCP server: |   | 
	| DHCP client: |   | 
	| DHCP relay: |   | 
	| Dynamic DNS client: |   
 | 
	| QoS: |   | 
	| UPnP: |   | 
	| Transparent Bridging (IEEE 802.1d): |   | 
	| Routing Protocols: | RIP v1 (static routing, RFC 1058) RIP v2 (dynamic routing, RFC1389)
 VLAN tagging (802.1q)
 IGMP Multicast (RFC 1112)
 | 
		
		| DSL | 
	
	| DSL compliance: | ADSL1  (G.dmt 992.1, G.lite 992.2, G.hs 994.1, DMT T1.413) ADSL2  (G.992.3, G.lite.bis 992.4)
 ADSL2+  (G.992.5)
 | 
	| PPPoE client: |   | 
	| PPPoA client: |   | 
		
		| VoIP | 
	
	| VoIP Protocols: | SIP v2 (RFC 3261) RTP / RTCP (RFCs 1889/1890)
 T.38 (Fax over IP)
 | 
	| VoIP Audio Codecs: | G.711 (PCM) G.726
 G.729 (a/b)
 | 
	| VoIP Voice Features: | Echo Cancellation (G.165/G.168) 3-way conferencing
 Caller ID
 Call waiting
 Call transfer
 | 
		
		| Wireless | 
	
	| Maximum Wireless Speed: | 54 Mbps | 
	| WiFi standards supported: | 802.11b (Wi-Fi 1) 802.11g (Wi-Fi 3)
 | 
	| Wifi security/authentication: | WEP WPA (TKIP)
 WPA2 (AES)
 802.1X (EAP-MD5/TLS/TTLS/PEAP)
 SSID Broadcast disable
 | 
	| WiFi modes: | Access point Repeater mode
 | 
	| internal antenna(s): | 1 | 
	| external antenna(s): | 1 | 
	| Antenna gain: | 3 dBi | 
	| Transmit Power: | +13 dBm | 
	| Receiver Sensitivity: | -68 dBm | 
		
		| VPN | 
				
		|  | IPSec | 
	
	| IPSec passthrough: |   | 
    			
		|  | PPTP | 
	
	| PPTP passthrough: |   | 
    		
		| Firewall | 
	
	| DoS / DDoS protection: |   | 
	| Filtering: | Domain/URL blocking, IP Address filtering | 
		
		| Device Management | 
	
	| Default IP address: | 192.168.1.1 | 
	| Default admin username: | admin | 
	| Default admin password: | admin | 
	| Administration: | Web-based (LAN) Remote configuration (WAN)
 Quick Setup Wizard
 Telnet / CLI
 SSH
 | 
	| Firmware upgradeable: |   | 
	| Configuration backup/restore: |   | 
	| Event log: |   | 
	| Diagnostic functions: |   
 | 
		
		| Misc hardware info | 
	
	| Chipset: | Broadcom BCM6348 | 
	| SNMP support: | SNMP v.1, SNMP v.2 | 
		
		| Links | 
	
	| Datasheet: | http://www.dynalink.co.nz/__data/assets/... | 
	| Manual: | http://www.dynalink.co.nz/__data/assets/... | 
	| Quick Install Guide: | http://www.dynalink.co.nz/__data/assets/... |