Port 2404 Details
known port assignments and vulnerabilities
4 records found
||An issue was discovered in Siemens ETA4 firmware (all versions prior to Revision 08) of the SM-2558 extension module for: SICAM AK, SICAM TM 1703, SICAM BC 1703, and SICAM AK 3. Specially crafted packets sent to Port 2404/TCP could cause the affected device to go into defect mode. A cold start might be required to recover the system, a Denial-of-Service Vulnerability.
References: [CVE-2016-7987], [BID-93832]
||IEC 60870-5-104, used to send electric power telecontrol messages between two systems via directly connected data circuits (official)
||IEC 60870-5-104 process control over IP
« back to SG Ports
SANS Internet Storm Center: port 2404
Well Known Ports: 0 through 1023.
Registered Ports: 1024 through 49151.
Dynamic/Private : 49152 through 65535.
TCP ports use the Transmission Control Protocol. TCP is the most commonly used protocol
on the Internet and any TCP/IP network. Whereas the IP protocol deals only with packets, TCP enables two hosts
to establish a connection and exchange streams of data. TCP guarantees delivery of data
and that packets will be delivered in the same order in which they were sent.
Guaranteed communication/delivery is the key difference between TCP and UDP.
UDP ports use the Datagram Protocol, a communications protocol for the Internet network,
transport, and session layers. Like TCP (Transmission Control Protocol),
UDP is used with IP (the Internet Protocol) and makes possible the transmission of datagrams
from one computer to applications on another computer, but unlike TCP, UDP is connectionless
and does not guarantee reliable communication; it's up to the application that received
the message to process any errors and verify correct delivery. UDP is often used with time-sensitive
applications, such as audio/video streaming, where dropping some packets is preferable to waiting for delayed data.
When troubleshooting unknown open ports, it is useful to find exactly what services/processes are listening to them.
This can be accomplished in both Windows command prompt and Linux variants using the "netstat -aon" command.
We also recommend runnig multiple anti-virus/anti-malware scans to rule out the possibility of active malicious software.
For more detailed and personalized help please use our forums.
Please use the "Add Comment" button below to provide additional information or comments about port 2404.