Burnt Motherboard...need some future tips

Anything related to hardware (CPU/MoBo/Video/FSB/BIOS, etc.), hardware settings, overclocking, cooling, cool cases, case mods, hardware mods, post pics of your unique creations here.
Post Reply
User avatar
Gundamflare
Regular Member
Posts: 252
Joined: Wed Jul 11, 2001 9:15 am

Burnt Motherboard...need some future tips

Post by Gundamflare »

Well, I had a feeling something like this was going to happen, but before I purchase a new mobo and proc, I need to make sure I don't make the same mistakes. It was a second hand mobo with a person who took care of his equipment well. One night, I was just talking on AIM, and the monitor just jumped into standby (the irony). I turned off the CPU, booted it back up, no avail, tried taking out the video card...put it back in, booted it up, negative. Swapped cards for 1 last ray of hope, still nothing. I took it to a friends house who suggested we clear the CMOS, we replaced the jumper (its an Asus A7V266-E KT266A AA), it started to smoke from the bottom, and was pronounced dead shortly after.

What could have caused this? we found the processor was chipped too. Are there any steps I can take to ensure that this will not happen again?
Subject to change.

New computer =)
User avatar
Unholy
Posts: 2819
Joined: Sun Mar 18, 2001 12:00 pm
Location: Somewhere Over There

Post by Unholy »

Not powerfull enough PSU? Anyways that's the first time I've ever heard of a mobo actually die with smoke comming out of it. Mines just died a quiet death without all that fancy pyrotechnics.

*Plz disregard my mindless ramblings not enough sleep*
"I was once banned from a bookstore for moving all the bibles to fiction"
User avatar
A_old
Posts: 10663
Joined: Sun Jan 30, 2000 12:00 am
Location: Atlanta

Post by A_old »

my first thought would be that the board was not properly grounded. u should make sure to put copper spacers under every hole in the MB and put a screw in every hole on the MB to attach it to the case firmly. This is a MUST. Also, becareful...if a screw falls under it, find it. keep your cables tidy so as not to give a chance for trouble..keep it dust free..dust and/or moisture will cause shorts...and bring smoke/burn.. that = = bad.

Amro
SLK
Posts: 2394
Joined: Tue Jan 22, 2002 9:48 pm
Location: Pittsburgh, PA

Post by SLK »

also, be careful with the Arctic Silver. Use it sparingly ;)
Rob
Post Reply