Windows networkin problem.

Networking, Wireless Routers (802.11 a/b/g/n/ac/ax WiFi), NAT, LAN configuration, equipment, cabling, hubs, switches, and general network discussion
Post Reply
fragbait
Member
Posts: 43
Joined: Sat May 05, 2001 12:00 am

Windows networkin problem.

Post by fragbait »

hi, im having trouble with getting onto the internet with one of my computers.. Heres my setup
2 computers 1 with xp/linux one with 2000
both go thru linksys router to cable modem

The computer with 2000 was workin a few days ago, but now it cant go on the interent. It can ping the router and the cable modem, and access the Router Page, but for some reason it cant access the cable modems page (Surfboard 3100) or any other webpage..... Ive tried reformmating, flush dns with the ipconfig command, and switching OSes... Also ive tried different NICs, and nothings working. On the other hand the other puter is workin fine both in xp and linux... Anybody know what could be the problem? Im sure i have the dns servers right, and even if i dont i should be able to access the modem page... Thanks!
User avatar
BaLa
SG VIP
Posts: 14410
Joined: Sun Dec 10, 2000 12:00 am
Location: 3MV6+W4 Temple, Texas
Contact:

Post by BaLa »

do you have it set to DHCP?
fragbait
Member
Posts: 43
Joined: Sat May 05, 2001 12:00 am

Post by fragbait »

for the wan yes.. but for local no, im specifyin local
User avatar
BaLa
SG VIP
Posts: 14410
Joined: Sun Dec 10, 2000 12:00 am
Location: 3MV6+W4 Temple, Texas
Contact:

Post by BaLa »

try setting the LAN to DHCP


after a reformat of one of the comps; it would not work with Static IP after I set the comp to DHCP it worked fine...
just an idea....
fragbait
Member
Posts: 43
Joined: Sat May 05, 2001 12:00 am

Post by fragbait »

damnit still no work... It wasnt working before i reformatted also. =(
User avatar
BaLa
SG VIP
Posts: 14410
Joined: Sun Dec 10, 2000 12:00 am
Location: 3MV6+W4 Temple, Texas
Contact:

Post by BaLa »

could it be a bad cable?

if thats not it somebody else might better be able to assist you...

that's the only other thing I can think of...
fragbait
Member
Posts: 43
Joined: Sat May 05, 2001 12:00 am

Post by fragbait »

omfg freakin weird, the connection for this puter (the other box) went out in windows as well!, but it works perfectly fine in LINUX!!!!!!! somethings rong! anybody?
User avatar
Technoid
Member
Posts: 63
Joined: Sun Jul 14, 2002 11:46 pm
Location: TinnySee

Post by Technoid »

Try flushing the router (quick press of the reset button on rear. Holding for 3 seconds or so will reset your config).
Try different ports to rule out port gone bad.
Flush the cable modem. Power down (pull the plug) for 15 minutes or so.
JD :nod:
"Knowledge is power if you have the manual".
Post Reply