mtu adjust for router someone?

Carla C · Post by **Carla C** » Wed Mar 06, 2002 9:18 pm

Hiya all!

It's been a while

.

Can someone tell me the command to adjust the mtu again of a router?

I usually telnet in and type something like "ipadj 1480 blah blah"

I haven't done it in so long that I forgot pls help!!

Carla

P.S Hi Lobo!!!!!!!!!!

Lobo · Post by **Lobo** » Wed Mar 06, 2002 9:20 pm

Hi Carla, I have not written as that E-mail addy don't work, hold on and I will get PPPoE man here

Carla C · Post by **Carla C** » Wed Mar 06, 2002 9:24 pm

Hi Lobo!!

Thank you I will keep checking back

talk to you soon

Carla

Bob Carrick · Post by **Bob Carrick** » Wed Mar 06, 2002 9:56 pm

Most routers havea web interface to do this, so I can only assume you are talking about a Netgear router.
1) Go to Start Menu -> Run -> type "telnet 192.168.0.1" -> click OK
2) Enter your password... (the default is 1234).
3) In the menu type "24" click Enter then "8" and click Enter
4) In the command line interface type "ip adjmss xxxx"
where xxxx is the MSS value" -> Click Enter
5) Type "Exit" -> Click Enter
6) Log in to your router, disconnect your connection then have your router reconnect.

Carla C · Post by **Carla C** » Wed Mar 06, 2002 10:03 pm

Hi Bob,

Thank you for replying. I was just at your site thanks to Lobo for directing me there.

Very good site! Lots of info and very organized thanks!!!

Carla

Bob Carrick · Post by **Bob Carrick** » Wed Mar 06, 2002 10:15 pm

Thanks for the kind words, hopefully something there helped out.

Carla C · Post by **Carla C** » Thu Mar 07, 2002 10:31 am

Hi Bob,

You're welcome!

I will be visiting your site very often

. Lots of things I can learn from there

. Thanks for your work.

Carla