a question about usb

gbrown · Post by **gbrown** » Tue Mar 13, 2001 11:42 pm

I am trying to add two additional usb ports using the header on my SE6, the only problem is I can't find any long enough to reach the header. Can anyone tell if it would hurt to extend the cables? Where do I get the shielded cable or do I need shielded cable? I know I can phisically solder in extra lenght, but will this cause any problems? I am trying to add the usb ports to the front of my case so if anyone has seen a pre made bay sized piece that would help also,I do not want a hub because I am out of space.

colour · Post by **colour** » Wed Mar 14, 2001 1:33 pm

should of gotten an add in card.

drewwpb · Post by **drewwpb** » Thu Mar 15, 2001 12:28 am

I have seen what you are talking about from Plycon.com, but I have not been able to get into them for a few days....Here's another place you can try..USB Bay Ports.....

[ 03-15-2001: Message edited by: drewwpb ]