sorry no help

boobik2381 · Post by **boobik2381** » Sat Dec 02, 2006 11:25 am

I'm at a total loss I don't know how to connect through the wire. I have netgear super g router set up that works fine when i try to connect wirelessly. But when I try to connect through the ethernet cable it says litmted connectivity or something like that( and cant find the ip address?). How can I go back to connect through my cable, then return fine to the router? I'd appreciate any help

press2esc · Post by **press2esc** » Mon Dec 04, 2006 3:37 pm

e, c(1) Check your ethernet cable(s) on another network - make sure you are getting a lit LAN light. If possible, connect PCs to a diff router/switch, hub, etc - just to see verify the ethernet cable(s).

(2) Make sure the TCP/IP protocol is enabled & the NIC(s) on the connecting PC(s) are enabled and "working properly".

(3) Try a different LAN port.

Good Luck,

P2E

P2E