This happens today..When I go to Control Panel/Network Connections... There isn't the icon with my connection .
That's my Question:
How can I reback this icon? ( to acess Tcp/ip properties... Firewall and so on)...
It seem be urgent!
I need Help!
I need Help!
This happens today..When I go to Control Panel/Network Connections... There isn't the icon with my connection .
That's my Question:
How can I reback this icon? ( to acess Tcp/ip properties... Firewall and so on)...
It seem be urgent!
Welcome to my world!
Is there an icon that is two computers in the bottom corner where the clock is
In Open Control Panel.
* Double-click Network and Dial-up Connections.
* Identify the icon for your cable modem connection: usually Local Area Connection.
* Right-click that icon and select Properties.
* Under the ethernet adapter icon, click the button Configure.
* Click the tab Advanced to bring it to the front:
* In the Property box, the property name to be selected varies according to model of ethernet card. Examples are: Network Link Selection, Media Type, Connection Type, Duplex Mode, or any similarly-named property which can have Values looking like Auto-Negotiation, or 10BT, or 10BaseT.
* In the Value box, select a value which either (a) explicitly says half-duplex or semi-duplex, or (b) at least does not say full-duplex [e.g. 10BaseT on its own is OK]. If there is a choice between 10 and 100 with half-duplex, choose the 10. Do not choose 10Base5, 10Base2, or AUI.
* Click OK to exit the Adapter settings.
* Click OK to exit the Connection properties.
In Open Control Panel.
* Double-click Network and Dial-up Connections.
* Identify the icon for your cable modem connection: usually Local Area Connection.
* Right-click that icon and select Properties.
* Under the ethernet adapter icon, click the button Configure.
* Click the tab Advanced to bring it to the front:
* In the Property box, the property name to be selected varies according to model of ethernet card. Examples are: Network Link Selection, Media Type, Connection Type, Duplex Mode, or any similarly-named property which can have Values looking like Auto-Negotiation, or 10BT, or 10BaseT.
* In the Value box, select a value which either (a) explicitly says half-duplex or semi-duplex, or (b) at least does not say full-duplex [e.g. 10BaseT on its own is OK]. If there is a choice between 10 and 100 with half-duplex, choose the 10. Do not choose 10Base5, 10Base2, or AUI.
* Click OK to exit the Adapter settings.
* Click OK to exit the Connection properties.
Comptia a+ n+