wifi boost

Networking, Wireless Routers (802.11 a/b/g/n/ac/ax WiFi), NAT, LAN configuration, equipment, cabling, hubs, switches, and general network discussion
Post Reply
forkz
New Member
Posts: 2
Joined: Sun Apr 09, 2017 7:46 pm
Location: north carolinat

wifi boost

Post by forkz »

hi all i am trying tto get wifi signal outside office where main router is to two houses less than 50 feet away have signal in both but its weak need this for streaming tv i am new here thanks for any and all help forkz
User avatar
Philip
SG VIP
Posts: 11734
Joined: Sat May 08, 1999 5:00 am
Location: Jacksonville, Florida

Post by Philip »

You may have to relocate the router if possible, the fewer obstacles there are the better.
If the router is older, upgrading to a 802.11ac router usually works better.
Ultimately, with longer distances it may be necessary to setup a wireless point-to-point bridge, however that requires some setup/knowledge/money.

To start with the simpler solutions, I'd look into what can be improved about the current router as far as location/obstacles between it and the client.
What are the models of the router/client, what speeds/standards do they support ?
What speeds are you getting when close to the router, vs. when at the destination ?
Blueblood78
New Member
Posts: 3
Joined: Tue Jun 27, 2017 4:49 pm

Post by Blueblood78 »

What about using extenders similar to a radio repeater? Might have some degradation on signal?
User avatar
Philip
SG VIP
Posts: 11734
Joined: Sat May 08, 1999 5:00 am
Location: Jacksonville, Florida

Post by Philip »

Residential Wireless Repeaters/Extenders use the same radio to communicate with both the main router and clients, reducing the wireless speed in half, and repeating a lot of unnecessary traffic, introducing noise. The speed over an extender is typically less than 50% of the normal WiFi speed, (and it is reduced by half with each hop), that's why we try to avoid them when possible. Alternatives include Access points, p2p bridges, and mesh wireless.
Post Reply