Anything I can do to improve my speed

[jasonruiz85]

Here are the test results:

TCP options string = 020405b401010402

MTU = 1500
MTU is fully optimized for broadband.

MSS = 1460
Maximum useful data in each packet = 1460, which is equal to MSS.

Default Receive Window (RWIN) = 65535
RWIN Scaling (RFC1323) = 0 bits
Unscaled Receive Window = 65535
Note: Under Windows 9x, if you have RWIN set to any other value, and the Analyzer reports 65535 you might need to install the MS Vtcp386 fix.
For optimum performance, consider changing RWIN to a multiple of MSS.
Other values for RWIN that might work well with your current MTU/MSS:
513920 (MSS x 44 * scale factor of 8)
256960 (MSS x 44 * scale factor of 4)
128480 (MSS x 44 * scale factor of 2)
64240 (MSS x 44)

bandwidth * delay product:
Your RcvWindow limits you to: 2621.4 kbps (327.675 KBytes/s) @ 200ms
Your RcvWindow limits you to: 1048.56 kbps (131.07 KBytes/s) @ 500ms

MTU Discovery (RFC1191) = ON

Time to live left = 112 hops
TTL value is ok.

Timestamps (RFC1323) = OFF

Selective Acknowledgements (RFC2018) = ON

IP type of service field (RFC1349)= 00000000

[MadDoctor]

Standard setup (nothing bad). No proxy. Nothing fancy. You can go like you are... or wait for someone smart to come along and tweak it some.

[Tick]

Almost like my testresult!

[funky]

Download the Vtcp patch from the same page you got your tweaks and reboot. post results again

[jasonruiz85]

ok here are the new results:

TCP options string = 020405b40103030301010402

MTU = 1500
MTU is fully optimized for broadband.

MSS = 1460
Maximum useful data in each packet = 1460, which is equal to MSS.

Default Receive Window (RWIN) = 513920
RWIN Scaling (RFC1323) = 3 bits
Unscaled Receive Window = 64240
RWIN is a multiple of MSS
Other values for RWIN that might work well with your current MTU/MSS:
256960 (MSS x 44 * scale factor of 4)
128480 (MSS x 44 * scale factor of 2)
64240 (MSS x 44)

bandwidth * delay product:
Your RcvWindow limits you to: 20556.8 kbps (2569.6 KBytes/s) @ 200ms
Your RcvWindow limits you to: 8222.72 kbps (1027.84 KBytes/s) @ 500ms

MTU Discovery (RFC1191) = ON

Time to live left = 112 hops
TTL value is ok.

Timestamps (RFC1323) = OFF

Selective Acknowledgements (RFC2018) = ON

IP type of service field (RFC1349)= 00000000

[earthmofo]

Looks good. Do a speed test to see how fast you are compaired to your service caps.

[jasonruiz85]

It still isnt fast. It starts at 400k/s for a sec then goes to 200k/s, then about 150. And me and Snake(who has really fast RR) live in the same city and he get about 600k/s.

[funky]

How close to ISP?

[Mark]

Originally posted by jasonruiz85
It still isnt fast. It starts at 400k/s for a sec then goes to 200k/s, then about 150. And me and Snake(who has really fast RR) live in the same city and he get about 600k/s.

do you mean me ?

are you using this site here ?

http://test.tampabay.rr.com/

that is where i get the most consistant speeds , it is local.



[edit] just tested there and got 674 average

[jasonruiz85]

Yes you, and no I still get 200-300 and then i goes down fast. And I did the test at the tampabay site and i get what you get, but like I said it slows down bad.

[funky]

Originally posted by Eugene4Pres
How close to ISP?

That might been the difference right there.

[HenryHand1]

Default Receive Window (RWIN) = 513920

Your RWIN is probably a little too high, but it might be ok. Go to http://www.dslreports.com/tweak and run the tweak test. Look at the middle column and see if there was packet loss, which I suspect there will be. Also, do you mean K/sec or kbps?

[jasonruiz85]

Yes, I did the test and it said I had a few retransmissions, what should I do?

[jasonruiz85]

help!