SG Broadband Community

hey everyone,

I have a wbr 1310 and i can't seem to get into the 192.168.0.1 to change any of the settings. I'm trying to put a password on my wireless network but since I can't get into the site, and I can't find the disk that they have for it, I can't do anything...

any ideas on something that might help me out would be greatly appreciated

Osiris

1) open web browser
2) on address line type in 192.168.0.1
3) this should bring up the router login page
4) if you haven't already logged in previously and changed the password, use Username: Admin and Password: Press <Enter> key
5) That "should" get you in

You can download the manual from:

http://office.manualsonline.com/manuals ... r1310.html

Look in the "Member Contributed Manuals" section

I know that, but the 192.168.0.1 address only brings me to a page that says that the link is broken

Connect by Cat5 and try again. Be sure the address is 192.168.0.1
From a cmd prompt, type ipconfig /all and see what the gateway IP is.