Page 1 of 1
Cat5e POE OK but No Data
Posted: Thu Jul 02, 2009 9:00 am
by RonLin
I have made up a number of CAT5e cables, (20 to 40metres) with RJ45 connectors. All the cables check out OK on my basic tester, that is all LED's are green.
I can use the cables to power the POE WAP, but I cannot ping the WAP or any device connected to the cable.
Any ideas where I am going wrong?
Posted: Thu Jul 02, 2009 9:02 am
by YeOldeStonecat
Was the WAP assigned an IP address? Is it a model that can pull from a DHCP service if it does't have one manually set? Or does it come with a pre-set static IP? Is that static IP in the same range as your main network that you're pinging from?
Posted: Fri Jul 03, 2009 7:24 pm
by RonLin
The WAP(s) have a static address and it works OK on other cables. The static IP and subnet is within range of the network.
My problem seems to be around the cable. I have since tried connecting the same cable to a my home broadband router. The cable does not allow any data connectivity and the leds do not light on the network card. However, it passes the tests on my basic cable tester (No short, open, reversed or miss-wired connection).
I have replaced the RJ45 plugs on the cable and the problem is the same. The cable will provide POE to the WAP but I cannot ping the WAP.
Posted: Sat Jul 04, 2009 7:50 am
by YeOldeStonecat
Have you tried a factory made cable?
Posted: Mon Jul 06, 2009 5:57 pm
by RonLin
Yes, tried a factory made cable. Worked OK.
However, still could not figure out where I was going wrong with the cables I made.
Are there different quality/grades of RJ45 connectors?
Posted: Tue Jul 07, 2009 6:14 am
by YeOldeStonecat
RonLin wrote:
Are there different quality/grades of RJ45 connectors?
And the crimpers
And the cables
And a big factor..how properly it's done.
To be honest with you....network cable "link lights" aren't really that useful. They'll only tell you if you have the pairs correct. They don't tell you how good the connection is, any attenuation (signal loss), how poorly untwisted the strands are on the ends, etc.
Posted: Tue Jul 07, 2009 5:56 pm
by RonLin
Hmm... The cables are solid (not stranded). I think I will replace the RJ45 connectors and try again.
Posted: Sun Jul 19, 2009 1:54 pm
by lucifercipher
The CAT5 cable lenght is too high and cable tester doenst transmit data , instead does a one to one pair testing. Try it under 20 meters and it should be ok. Power will transmit fine as you can see but the data loss occurs for the signal to reach. Ive been there myself once years back and had to put a switch in the middle to over come that.