Page 1 of 1
dumb scsi question
Posted: Mon Nov 15, 2004 10:40 pm
by zooner
i'm running an adaptec 29160 u160 with a cheetah 18gig 15k 68-pin
any problem running this drive with it?
36.7 GB 10000 rpm Cheetah 10K.6 Internal 68-Pin Ultra320 SCSI Hard Drive
I might pick it up from dell or look around for one. I'd like to setup a scsi gaming hard drive.
Posted: Mon Nov 15, 2004 11:10 pm
by lansens
Should be fine.
Posted: Tue Nov 16, 2004 2:54 am
by loop2kil
yep should work fine
Posted: Wed Nov 17, 2004 10:39 am
by Ken
It should work, no problems, with a data transfer rate of 160 MB/sec...
The 29160 has a transfer rate of 160 MB/sec, your new hdd has a potential rate of 320 MB/sec...
Posted: Wed Nov 17, 2004 4:49 pm
by YeOldeStonecat
Ken wrote:It should work, no problems, with a data transfer rate of 160 MB/sec...
The 29160 has a transfer rate of 160 MB/sec, your new hdd has a potential rate of 320 MB/sec...
Technically, it's the U320 bus itself that has the potential to spit out 320 megs...the drive itself will never get even near 1/3 of that.

Posted: Wed Nov 17, 2004 9:42 pm
by zooner
thanks!
I image I can pick up a 18-36gig scsi 10k for pretty cheap. Plenty fast enough for a gamin HD.