Results 1 to 6 of 6

Thread: My new parts are here!

  1. #1
    Folding Thunder
    Join Date
    Mar 2002
    Location
    New York The Empire State
    Posts
    10,543

    Talking My new parts are here!

    Finally got the rest of my new parts today!

    Eheim pump # 1048
    Corsair XMS 512Mb PC3200 cas2 Platinum
    AS3

    Just went to Home depot and bought the misc. parts to finally get my H20 up and running! Wahooooooooo!!!

    Here's the good and the bad:

    Good: Installed the 512Mb Corsair and i'm running Turbo settings cas2 with 2.6v on the vdimm. Xcellent performance and great sandra scores!

    Bad: I can't go pass 190fsb without my vid card crappin out on me When i pass 192 i get bad artifacts and color spots. My freakin Ti4200 is holding me back from the 2Ghz!

    Dammit, i'm sooooo close! Now i bet fish is gonna enjoy this

    Here i am gettin ready to fry his fillet, and my vid card is gagging!

  2. #2
    Advanced Member fish59's Avatar
    Join Date
    Oct 2000
    Posts
    606
    More VDIMM
    I know your board can go higher.That Corsair doesn't crap out till well over 3.0

  3. #3

  4. #4
    Folding Thunder
    Join Date
    Mar 2002
    Location
    New York The Empire State
    Posts
    10,543
    Hmmmmm, i was thinking about that. I'll give it a shot and see. I know it ain't the ram, it's gotta be the vid card.

    Don't worry fish, i ain't backin out. It's gonna take alot more for me to back off! As the PC Gods are looking down on me, your fillet is batterd and fried mister!

  5. #5
    Advanced Member fish59's Avatar
    Join Date
    Oct 2000
    Posts
    606
    Take off the NB heatsink,remove tape,Use 50/50 mixture AS epoxy/AS III,reapply NB sink,screw on 40mm fan.

    A cooler NB helps eliminate the AGP tearing.
    Or get a chipset block for your water.

  6. #6
    Folding Thunder
    Join Date
    Mar 2002
    Location
    New York The Empire State
    Posts
    10,543
    Originally posted by fish59
    Take off the NB heatsink,remove tape,Use 50/50 mixture AS epoxy/AS III,reapply NB sink,screw on 40mm fan.

    A cooler NB helps eliminate the AGP tearing.
    Or get a chipset block for your water.
    I've got a crystal orb on the NB with 50/50 mix.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •