Results 1 to 2 of 2

Thread: DefaultTTL And UDP

  1. #1

    DefaultTTL And UDP

    I have identified a command to change UDP ports (same as maxuserport) is this recommended? netsh int ipv4 set dynamicport udp start=1025 num=64511

    about DefaultTTL why the value 64 is more recommended than the maximum (255)

  2. #2
    Administrator Philip's Avatar
    Join Date
    May 1999
    Jacksonville, Florida
    Blog Entries
    The dynamic user ports are allocated in sequence, it only makes a difference if all are used, which is very rare.

    The TTL defines when a packet is considered lost, and is resent. Most normal connections use TTL of 10-15 hops, maybe up to 20-30 if it is a very "distant" in network terms server. A route longer than 32 hops is rare, I don't think I've seen a route longer than 64 hops. The reasoning is that if a packet travels more than that, it is likely that it is lost, or in some type of route loop, so it can be discarded, and the sender should be retransmitting it. There is no good reason for it to live longer than 64 or 128 hops/seconds.

Similar Threads

  1. DefaultTTL
    By hihi in forum Broadband Tweaks Help
    Replies: 7
    Last Post: 05-26-02, 08:43 AM
  2. DefaultTTL
    By MrTRiX in forum General Broadband Forum
    Replies: 1
    Last Post: 07-22-01, 09:28 PM
  3. DefaultTTL Opinions needed
    By Methan in forum General Broadband Forum
    Replies: 0
    Last Post: 01-15-01, 09:30 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts