> Got a fairly new DI-604 revE router that failed a firmware update.
> It had firmware 3.38 and I downloaded 3.53 from D-Link. I began the
> firmware update with IE6 and after a few seconds I got
> an error saying something like "Incorrect formatted media" or
> something like that. I clicked OK and the router said it was
> rebooting. Well, that was the end of that!!! Now when I try to access
> the router I get "Firmware Upgrade" with a box that says "Browse for
> file" and a button that says "Send" in IE6 . I click Browse and
> select the proper firmware, then click "Send" it tries sending the
> firmware to the router for a few seconds than I get "Page not
> Found"...... I googled for help and found all kinds of ways to reset
> the router to a working state again but none worked.
> I bought 2 of these routers new 2 years ago. Ones in use but has
> started acting up. This one was the backup router for when the first
> one failed...... I used the same firmware a few weeks ago trying to
> resurrect the first router that's acting flaky but it didn't help,
> that router is still screwing up, but not from the firmware upgrade.
> I really need to get this new router back up and running if at all
> possible...... Anyone know of a way to force a flash on this router
> or a way to reset it that works ?????
> Thanks in advance
It may have been a bad software download of the firmware Check at
http://www.mydumbblogs.com/technolog...-firmware.html for a list
of available firmware.
With the right hardware revision even an older rev firmware is better than a
totally non-working unit.
Might be worth a read at this link as well.