Results 1 to 2 of 2

Thread: port 110

  1. #1
    Texas T
    Guest port 110

    Forgive me I'm new to this site and I hope I've posted this in the right section..
    But here is my question I am in building automation and I have a building we set up and the system we are using needs to send out alarm notification. The problem I have is that the controls we are useing does not support SSL. The cust ordered which uses port 995 and 465 which are SSL Normally we would have a IP tech take care of this but we do not have that option at this building. Again forgive me but I usually do not have to do this side of it so I may not know all the lingo. But anyway I called att tech support and was told to use ( and port 110 for outgoing I don't care about the incoming port because all we are doing is sending alarms out but I tried port 110 with no luck. I search around and read that I could use port 25 and 587 I've tried these as well with no luck. Any input would be greatly appreciated.

  2. #2
    Moderator YeOldeStonecat's Avatar
    Join Date
    Jan 2001
    Somewhere along the shoreline in New England
    That should still be on port 25 with the primary account credentials needed, non-SSL.
    MORNING WOOD Lumber Company
    Guinness for Strength!!!

Similar Threads

  1. Replies: 1
    Last Post: 11-30-10, 09:29 AM
  2. (long post) New system and new tech advice and help.
    By osuprowler in forum Hardware & Overclocking
    Replies: 11
    Last Post: 10-07-08, 11:05 PM
  3. Problem in Port Forwarding for Windows Remote Desktop or VNC
    By Alterego in forum Networking Forum
    Replies: 4
    Last Post: 09-17-08, 10:22 AM
  4. Are they rationing rice in your area yet?
    By RoundEye in forum General Discussion Board
    Replies: 10
    Last Post: 04-24-08, 09:21 PM
  5. Katrina victim sues U.S. for $3 quadrillion
    By YARDofSTUF in forum General Discussion Board
    Replies: 44
    Last Post: 01-31-08, 02:33 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts