Hi, i bought a Cisco 2621 Router. I am trying to congifure it to my network. I can get the LAN to configure but i cant connect the router to my DSL modem. My SBC yahoo DSL uses PPPoE with a dynamic IP address. I read on sites that i need to go in and in the config menu enter this command "vpdn enable" and then there are a few more sets after that.

Well in my case, the vpdn command is not recongized at all! I even type ? and dont see the command in the menu. Maybe am i running the wrong firmware? Does anyone have the correct firmware i would need and could they help me with updating the unit, i would very much appreciate it!.

Here is my boot up sequence...

System Bootstrap, Version 12.2(10r)1, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2002 by cisco Systems, Inc.
C2600 platform with 32768 Kbytes of main memory

program load complete, entry point: 0x80008000, size: 0x54ab60
Self decompressing the image : #################################################
######################################################### [OK]

Smart Init is disabled. IOMEM set to: 25

Using iomem percentage: 25

Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706



Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.2
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Thu 19-Jun-03 16:35 by pwade
Image text-base: 0x8000808C, data-base: 0x80A14C38

cisco 2621 (MPC860) processor (revision 0x00) with 24576K/8192K bytes of memory.

Processor board ID JAD06400DEL (2005750629)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/W