PDA

View Full Version : My new parts are here!



LT-73
12-03-02, 08:09 PM
Finally got the rest of my new parts today!

Eheim pump # 1048
Corsair XMS 512Mb PC3200 cas2 Platinum
AS3

Just went to Home depot and bought the misc. parts to finally get my H20 up and running! Wahooooooooo!!! :D

Here's the good and the bad:

Good: Installed the 512Mb Corsair and i'm running Turbo settings cas2 with 2.6v on the vdimm. Xcellent performance and great sandra scores!

Bad: I can't go pass 190fsb without my vid card crappin out on me :( When i pass 192 i get bad artifacts and color spots. My freakin Ti4200 is holding me back from the 2Ghz! :mad:

Dammit, i'm sooooo close! Now i bet fish is gonna enjoy this :rolleyes: :(

Here i am gettin ready to fry his fillet, and my vid card is gagging!

fish59
12-03-02, 08:39 PM
More VDIMM
I know your board can go higher.That Corsair doesn't crap out till well over 3.0

fish59
12-03-02, 08:41 PM
2Ghz! aint gonna do it.

http://forums.speedguide.net/showthread.php?s=&threadid=98332&pagenumber=2

LT-73
12-03-02, 09:27 PM
Hmmmmm, i was thinking about that. I'll give it a shot and see. I know it ain't the ram, it's gotta be the vid card.

Don't worry fish, i ain't backin out. It's gonna take alot more for me to back off! As the PC Gods are looking down on me, your fillet is batterd and fried mister! :p

fish59
12-03-02, 09:48 PM
Take off the NB heatsink,remove tape,Use 50/50 mixture AS epoxy/AS III,reapply NB sink,screw on 40mm fan.

A cooler NB helps eliminate the AGP tearing.
Or get a chipset block for your water.

LT-73
12-03-02, 10:43 PM
Originally posted by fish59
Take off the NB heatsink,remove tape,Use 50/50 mixture AS epoxy/AS III,reapply NB sink,screw on 40mm fan.

A cooler NB helps eliminate the AGP tearing.
Or get a chipset block for your water.

I've got a crystal orb on the NB with 50/50 mix.