PDA

View Full Version : ATX Case hookup to Asus K7M



Cameron203
09-14-02, 02:42 AM
Here is a direct link to my mobo ftp://ftp.asus.com/pub/ASUS/mb/slota/k7m/k7m-104.pdf if you look on page 43 it shows you how to hook up the case to the mobo. My question is I have the power LED and the power switch the reset and the speakers hooked up, but I was wondering I have a 2 pin wire labeled HDD LED that I don't know where it goes and also I have 2 front usb ports and mic and headphone jack that has wires to run into the mob I also don't know where it goes.

There is a diagram also on page 43 right above the atx hookup labeled USB Connector but I don't know how to hook it up i have 9 1 pin wires for the usb front ports labeled 1+5V, 2+5V, 1-D, 1+D, 2-D, 2+D, 1 Ground, 2 Ground, Shield


If anyone can help I appreciate it. Thanks

Sid
09-14-02, 09:04 AM
For your HDD led look on page 39 at the top. It will say IDE activity light. Page 39 shows where to hook the USB at the mother board.

Cameron203
09-14-02, 02:18 PM
Ok I see the LED for the HD now but I don't see how to hook up the USB on page 39. I see on Page 43 but it doesn't match my wires???