PDA

View Full Version : I've gone mod crazy!



drdoug99
04-22-02, 01:07 AM
Since I installed the 2 blowholes and fans, I've added 2 more small fans...I think 40mm in the rear panel, and cut some more parts of my case off for better airflow.

now i'm considering purchasing this window kit (http://www.xoxide.com/16x14lexankit.html)

does this kit seem good for the price and everything?

i've never installed a window kit before, what does the sealent do? I assume I'd just cut out a pattern out, and make the same pattern on the window, and on the case panel, then just form the rubber seal around the window and my case to complete the "molding" or whatever...

any tips? thanks again.

Ken
04-22-02, 01:19 PM
Hey Doug, If you mention that you saw it on PriceWatch, you can get it for $14 instead of $19.99... ;)
Who luvs ya! :D

http://www.pricewatch.com/ (if the page times out, just enter "window kits" and you will see their special, and save $5. Shipping is $4-7, so the savings will pay for shipping!!)


Case window kit.
Do it yourself 16x14 window kit MUST MENTION PRICE WATCH - Includes: 5ft rubber molding, Huge 16x14 Acrylic panel, and sealant.

Looks great with light kits and window etches. $ 14

Shipping:$4.00-$7.00 Insured

Xoxide Modifications
610-353-1634
610-996-8036
PA

RoundEye
04-22-02, 04:57 PM
Look at the couple of pics of my case in this thread (http://forums.speedguide.net/showthread.php?s=&threadid=73896&perpage=15&pagenumber=2), there's also some instruction on how I cut the hole. What I did was buy some acrylic material from Home Depot. I cut it to size and cut a hole in the top of the case too. I used 3M automotive body molding tape that I got from Wal-Mart, to stick it to the case.

Just be careful when you stick the tape and the window on, when you stick that glass on, it is STUCK. Make sure the glass is where you want it before you stick it down.

Ken
04-22-02, 05:58 PM
A secret with working with some of that plexy-lucite material.
If you take and run a torch flame over a scratched or rough cut edge, it will change it to look like a glass factory edge!
(check it on a piece of scrap first, to verify that it works on your specific material and to give you an idea of how to do it... ;) )
It takes takes a second. DO NOT hold the flame on it as it will melt!!! Just keep running the flame over the edge in a back and forth motion and you will see...

A guy I knew a long time ago worked in that profession and showed me the trick! He was the guy that made the lucite box covers for the metal mannequins that I had made for my client that was into baseball memorabilia seriously! (Remember the thread about powder coating? I had told the details there...)

RoundEye
04-22-02, 06:29 PM
I do what your talking about with my heat gun. If your going to edge light the plastic it helps it glow a lot better with the edges cleaned. If you don't have a heat gun, sanding it with 1200 grit sandpaper will do the same thing, only it takes a lot longer.

drdoug99
04-23-02, 12:29 AM
thanks Ken and Round Eye! ordering the window kit now! :)

tHE_0ne
04-23-02, 03:39 PM
post some pics, when you get done installing it