My cool case

[mikemean]

NOT But I wanted to be the first to post a picture:p
http://home.attbi.com/~mikemeanmt/case.jpg

[Mark]

what kind of case is that Mike ?

i cannot what till i get my scanner then i can post mine.

[HalfLifer]

gateway :)

[mikemean]

Originally posted by HalfLifer
gateway :)

:nod: :nod: POS Gateway, but at least it's a puter. They call it the "flex" case. About the size of a VCR, but I can't add any PCI cards cause the damn case is too small:mad:

[blebs]

That's a shame. You should have got the mid tower case, but that might not have been an option. :(

[BaLa]

if you have the money, you could just buy a new mid-tower case..
a switch over is very easy..

[mikemean]

Originally posted by BaLa
if you have the money, you could just buy a new mid-tower case..
a switch over is very easy..

See, that's what I have been thinking. Recycling my old parts and put them in a new mobo and case.

[BaLa]

new mobo?

uh well..
I would put it in a new case first..
then later on..
additionaly (don't know how much you know) this will give you some experience..

[mikemean]

The mobo is specific to gateway. I highly doubt it will go into a different case. It's a tiny little thing too.

[BaLa]

Originally posted by mikemean
The mobo is specific to gateway. I highly doubt it will go into a different case. It's a tiny little thing too.

um well..
if it's a standard ATX/Micro ATX board it will fit..
.
my old emachines board fit in a diff case..

[mikemean]

Originally posted by BaLa


um well..
if it's a standard ATX/Micro ATX board it will fit..
.
my old emachines board fit in a diff case..

I have 3 USB ports in the back and two in the front. Do you still think it would go into a different case?

[YARDofSTUF]

Originally posted by mikemean


I have 3 USB ports in the back and two in the front. Do you still think it would go into a different case?

nope!

EDIT: teh front usb posts are most likey part of the case and u could have them on a new case but i'd leave it as is until u decide to upgrade.