Have to hit enter to start new WU?

[Scoot]

Whenever I complete a unit the console does not reconnect unless I bring it up and hit enter?
What have I done wrong?
Folding@home version 1.33b
Here is the actual entry:

Finished Work Unit: Sending results
- Reading upto 100 8-byte entries from "project.bed": Read 100 successfully
- Reading upto 2 8-byte entries from "project.evd": Read 2 successfully
- Connecting to server (IP = 171.64.122.94)
> Press enter to connect to the server

Then it stalls until I check where I am at.

[ 02-04-2001: Message edited by: Scoot ]

[Knine]

look in client.cfg in your folding@home dir and look for ask= and make sure it is no and not yes if you have to make a change you will have to restart fah beofore it takes affect (i think)

[Scoot]

Originally posted by -Knine-:
look in client.cfg in your folding@home dir and look for ask= and make sure it is no and not yes if you have to make a change you will have to restart fah beofore it takes affect (i think)
Well I did that,and changed it to no before I posted.
You are right,I think I have to restart.
Good think it saves your work :)
The G@H console does not,so if you stop for any reason you lose your work :(