The integrated access point complies with IEEE 802.11b/g standards, providing wireless transmission speeds of up to 54Mbps. It can operate in AP and Repeater modes and supports WEP and WPA/WPA2 wireless encryption.
The RTA1046VW provides a variety of VoIP features, such as Caller ID, 3-Way Conferencing and Echo Cancellation.
This router provides VPN pass-through for IPSec and PPTP. It features a built-in firewall to protect the network from intruders and Denial of Service (DoS) attacks.
| RTA1046VW Features | |
| General | |
| Availability: | discontinued |
| LAN / WAN Connectivity | |
| WAN throughput: |
24 Mbps |
| WAN throughput upstream: |
1 Mbps |
| WAN ports: |
1 |
| WAN port(s) type: | DSL/ISDN/POTS connector (RJ-11) |
| LAN ports: | 4 |
| LAN ports type: | 10/100 Base-TX (RJ-45) |
| LAN ports auto cross-over: |
 |
| RJ-11 FXS VoIP phone ports: | 2 |
| RJ-11 FXO VoIP PSTN wall jack port: | 1 |
| Router | |
| NAT routing: |
|
| Multihomed: |
|
| DMZ: |
|
| Port forwarding: |
|
| Port triggering: |
|
| DHCP server: |
|
| DHCP client: |
|
| DHCP relay: |
|
| Dynamic DNS client: |
|
| QoS: |
|
| UPnP: |
|
| Transparent Bridging (IEEE 802.1d): |
|
| Routing Protocols: |
RIP v1 (static routing, RFC 1058) RIP v2 (dynamic routing, RFC1389) VLAN tagging (802.1q) IGMP Multicast (RFC 1112) |
| DSL | |
| DSL compliance: |
ADSL1 (G.dmt 992.1, G.lite 992.2, G.hs 994.1, DMT T1.413) ADSL2 (G.992.3, G.lite.bis 992.4) ADSL2+ (G.992.5) |
| PPPoE client: |
|
| PPPoA client: |
|
| VoIP | |
| VoIP Protocols: |
SIP v2 (RFC 3261) RTP / RTCP (RFCs 1889/1890) T.38 (Fax over IP) |
| VoIP Audio Codecs: |
G.711 (PCM) G.726 G.729 (a/b) |
| VoIP Voice Features: |
Echo Cancellation (G.165/G.168) 3-way conferencing Caller ID Call waiting Call transfer |
| Wireless | |
| Maximum Wireless Speed: | 54 Mbps |
| WiFi standards supported: |
802.11b (Wi-Fi 1) 802.11g (Wi-Fi 3) |
| Wifi security/authentication: |
WEP WPA (TKIP) WPA2 (AES) 802.1X (EAP-MD5/TLS/TTLS/PEAP) SSID Broadcast disable |
| WiFi modes: |
Access point Repeater mode |
| internal antenna(s): | 1 |
| external antenna(s): | 1 |
| Antenna gain: | 3 dBi |
| Transmit Power: | +13 dBm |
| Receiver Sensitivity: | -68 dBm |
| VPN | |
| IPSec | |
| IPSec passthrough: |
|
| PPTP | |
| PPTP passthrough: |
|
| Firewall | |
| DoS / DDoS protection: |
|
| Filtering: | Domain/URL blocking, IP Address filtering |
| Device Management | |
| Default IP address: | 192.168.1.1 |
| Default admin username: | admin |
| Default admin password: | admin |
| Administration: |
Web-based (LAN) Remote configuration (WAN) Quick Setup Wizard Telnet / CLI SSH |
| Firmware upgradeable: |
|
| Configuration backup/restore: |
|
| Event log: |
|
| Diagnostic functions: |
|
| Misc hardware info | |
| Chipset: | Broadcom BCM6348 |
| SNMP support: | SNMP v.1, SNMP v.2 |
| Links | |
| Datasheet: | http://www.dynalink.co.nz/__data/assets/... |
| Manual: | http://www.dynalink.co.nz/__data/assets/... |
| Quick Install Guide: | http://www.dynalink.co.nz/__data/assets/... |
Please use the Add Comment function below to review devices you have used (please be descriptive).
If you find an error in our database, or have additional information about the product,
please
|
Post your review/comments
rate:
avg:
|
|
|