Page 1 of 1
ghost 2003 win 2k
Posted: Thu Sep 04, 2003 1:47 am
by joey
i installed the ghost on my w 2k pc and using the "clone" option to clone my HD.
when i am using the clone HD, on boot up i am getting a message
that the paging file is to small + instruction how to change it.
(it doesnt let me boot all the way up nithere in safe mode)
what is wrong?
( the ghost is set to work with the "pc dos" & not with ms dos - if it is any thing to with it)
thank you in advance
Posted: Thu Sep 04, 2003 2:17 am
by zooner
that the paging file is to small + instruction how to change it
what do the instructions say?
perhaps you should change the size of that virtual memory paging file. by default it's at 2megs, what is yours set to?
Posted: Thu Sep 04, 2003 5:58 am
by YeOldeStonecat
http://service1.symantec.com/SUPPORT/gh ... enDocument
May want to try grooming your initial source drive (checkdisk, defrag, recreate your pagefile as listed in the above link)...then attempting a clone again.
Booting from PC-Dos is fine, that's what the Ghost boot disk will use, I use it all the time.
Default size of the pagefile.sys I believe is varied...as the setting is "Let Windows Manage".
Posted: Thu Sep 04, 2003 11:49 am
by joey
i used the "drive copy" software to clone the HD end evry thing is working fine.
it is some thing to do with the ghost
Posted: Thu Sep 04, 2003 2:19 pm
by zooner
Originally posted by joey
i used the "drive copy" software to clone the HD end evry thing is working fine.
it is some thing to do with the ghost
it's just wierd.
I just used the exact same program yesterday, without any ills.
did you check for updates?
Posted: Fri Sep 05, 2003 2:22 am
by joey
you are right, i did the update and it's working good.
thank you
Re: ghost 2003 win 2k
Posted: Sat Sep 06, 2003 7:31 am
by Murman
Originally posted by joey
i installed the ghost on my w 2k pc and using the "clone" option to clone my HD.
when i am using the clone HD, on boot up i am getting a message
that the paging file is to small + instruction how to change it.
(it doesnt let me boot all the way up nithere in safe mode)
what is wrong?
( the ghost is set to work with the "pc dos" & not with ms dos - if it is any thing to with it)
thank you in advance
This happens quite often... take a windows 98 boot disk or get one at
http://www.bootdisk.com Boot off the floppy, once your at a DOS prompt type fdisk /MBR reboot, pop the floppy out and you'll be all set.
The boot record got corrupt.